Denso WAVE BHT-805BWB User Manual page 164

BHT-805BWB
5.
Use the cursor keys ([▲] [▼]) or numeric key ([3]) to highlight the [3: NUM RESPONSES] and
then press the ENT key.
Entry mode is activated and the cursor is displayed.
6.
Use the numeric keys to enter the desired value.
Set up the number of devices to detect.
This number is used only for the device detection ([1: DO IT] menu).
Valid Range: 0 – 8, Default: 0.
Detects a maximum of 8 devices when "0" is set.
Note that the setting specified here will not be saved.
To delete a single character, press the Backspace/clear key. To delete the entire entry, press and hold
the Backspace/clear key or press the SF and Backspace/clear keys simultaneously.
7.
Press the ENT key.
8.
Use the cursor keys ([▲] [▼]) or numeric key ([1]) to highlight the
[1: DO IT] and then press the ENT key.
The screen on the right is displayed and the device detection is started.
The device inquiry ends and the screen on the right is displayed
When;
・ The specified number of devices have been found.
・ The specified time has elapsed.
・ The Backspace/clear key has been pressed while detecting
devices.
Press the Backspace/clear key to return to the BROWSE DEVICE menu.
To set the detected device address as a destination remote device address for the master station,
use the cursor keys ([▲] [▼]) or numeric keys to select the desired address and then press the ENT key.
148