Denso WAVE BHT-805BWB User Manual page 160

BHT-805BWB
Setting up the serial port profile (SPP) service for the connection target
1.
Press numeric key [7] and the SF key simultaneously in the SET
MASTER menu to display the screen on the right.
[1: SPP SERVICE]:
Press the Backspace/clear key to return to the SET MASTER menu.
2.
Press the ENT key.
Entry mode is activated and the cursor is displayed.
3.
Use the numeric and period (.) keys to enter the serial port service name to connect.
Up to 12-characters can be entered. There is no default setting.
To switch the entry mode (between numeric and alphabet entries), press the SF key.
To delete a single character, press the Backspace/clear key. To delete the entire entry, press and hold
the Backspace/clear key or press the SF and Backspace/clear keys simultaneously.
4.
Press the ENT key.
5.
Press the Backspace/clear key to return the SET MASTER menu.
If the target remote device has two or more serial port services, the link is established with
− Point −
any of them. Specifying the serial port service name on the above screen selects the
specified one. For the service name of the destination remote device, refer to "[3] BROWSE
DEVICE menu" – "Searching for services".
144
Sets up the serial port service name for the
connection target.