Denso WAVE BHT-805BWB User Manual page 163

[3] Detecting remote devices
1.
Select "3: BROWSE DEVICE" in the BLUETOOTH MENU and
then press the ENT key.
The screen on the right is displayed.
[1: INQUIRY]:
[2: BROWSE SERVICE]:
[3: AUTH BD_ADDR]:
Refer to the following sections for each of the above menus.
Press the Backspace/clear key to return to the BLUETOOTH MENU.
Detecting devices
1.
Select "1: INQUIRY" in the BROWSE DEVICE menu and then
press the ENT key.
The screen on the right is displayed.
[1: DO IT]:
[2: INQUIRY TIME]:
[3: NUM RESPONSES]:
Press the Backspace/clear key to return to the BROWSE DEVICE menu.
2.
Use the cursor keys ([▲] [▼]) or numeric key ([2]) to highlight the [2: INQUIRY TIME] and then
press the ENT key.
Entry mode is activated and the cursor is displayed.
3.
Use the numeric keys to enter the desired value.
Set up the device inquiry time to detect devices.
The device inquiry time is used only for the device detection ([1: DO IT] menu).
Valid Range: 0 -255, Default: 10 seconds
Note that the setting specified here will not be saved.
To delete a single character, press the Backspace/clear key. To delete the entire entry, press and hold
the Backspace/clear key or press the SF and Backspace/clear keys simultaneously.
4.
Press the ENT key.
Sets up the device detection.
Searches the bluetooth services.
Displays a list of authenticated remote device
addresses.
Starts device detection.
Sets up the device inquiry time.
Sets up the number of devices to detect.
Barcode Handy Terminal
147