Motor Cover Removal
TOOLS NEEDED:
3 & 4mm Allen Head Wrench
●
UNPLUG UNIT BEFORE STARTING
Begin by folding the arms down, and then leaning the treadmill up against a surface for
easy access to the motor cover. Using a 3mm Allen Wrench, you will remove 11 bolts
in total: 7 on the bottom of the pan, and 2 on each wheel. Remove wheel plate on each
side, allowing you to remove the cover.
Using a 4mm Allen Wrench, remove the 4 bolts keeping the wheel and drive belt
pulley in place. (Fig A) Remove the wheel plate from the unit. (Fig B) Then, carefully
work the drive belt off the drive motor. (Fig C)
1 800 - LANDICE | SERVICE@LANDICE.COM | WWW.LANDICE.COM