Table of Contents
Advertisement
46
en | Operation
Figure 2.78 Set Time and Date screen
2.8.5
Walk Test
On the Service menu (Figure 2.64, Page 39), press Walk Test. The Walk Test screen
(Figure 2.79, Page 46) identifies the available options:
–
–
–
–
Figure 2.79 Walk Test screen
Start New Walk Test
NOTICE!
During a walk test, the Back and Home buttons are inactive. Exit (to the idle screen) is the
only active button. Because only certain personnel are authorized to execute a walk test, and
the test requires the person to leave the area near the control center, another user with the
same level of authority can only exit to the idle screen and log in with the appropriate
authority level. Doing so would interrupt the walk test.
To avoid an interruption of the test, the installer can place a note on the control center to
indicate that a test is in process.
From the Walk Test screen, press Start New Walk Test. The Walk Test Select screen
(Figure 2.80, Page 47) opens showing the following options:
–
–
F.01U.168.328 | 03 | 2011.05
Start New Walk Test
Resume Walk Test (This button is not active until after the first test is completed.)
Start Seismic Test
Print Walk Test (This button is not active until after the first test is completed.)
Select Areas
All Points
User guide
MAP Control Center
Bosch Security Systems, Inc.
Advertisement
Table of Contents
