Bosch IUI-MAP0001 User Manual page 21

MAP Control Center
Figure 2.20 Add Smartkey User screen
NOTICE!
The next three steps are optional in the Add User procedure.
14. If you wish to enter the Smartkey token's ID number at the control center, press Enter
Figure 2.21 Enter Smartkey Token Number keypad screen
15. On the Add Smartkey User screen (Figure 2.20, Page 21), press Select Smartkey Profile.
Bosch Security Systems, Inc.
Smartkey Token Number. The Enter Smartkey Token Number keypad screen
(Figure 2.21, Page 21) opens. Refer to Table 2.2, Page 12 for information about using the
commands at the bottom of the screen.
a. Use the on-screen keypad to enter the 8-character ID found on the Smartkey token.
The code appears in the Enter field and a Verify Code field appears.
b. Enter the same code again. The code appears in the Verify Code field.
c. Press OK.
If the token number in the Enter field matches the number entered in the Verify
Code field, the Smartkey token number appears in lighter text under the Enter
Smartkey Token Number button name on the Add Smartkey User screen. If these
numbers do not match, an error message is displayed, and you must re-enter the
token number and verify code.
The Select Smartkey Profile screen (Figure 2.23, Page 22) opens.
User guide
Operation | en 21
F.01U.168.328 | 03 | 2011.05