Table of Contents
Advertisement
13.0 Turning Outputs On/Off
This feature only applies if your installer set up an
output to be turned on or off by the codepad. Your
installer can program up to three outputs to control a
pool pump, outside lighting, and so on.
To turn an output on or off:
1. Enter your Master Code and press [5 #] (for
example, [2 5 8 0 5 #]).
Three beeps sound and the STAY and AWAY
indicators flash.
2. Enter the output number (1 to 3) you want to
turn on or off.
3. Press [#] to turn the output on, or press [*] to
turn the output off.
Three beeps sound if you turn the output on, and
two beeps sound if you turn the output off.
Repeat Step 2 and Step 3 to turn other outputs
on or off.
4. Press [#] to exit this function.
Two beeps sound and the STAY and AWAY
indicators turn off.
14.0 Reset Latching Outputs
This feature only applies if your installer
programmed an output to latch (remain on) until you
acknowledge the event that turned on the output.
To reset latching outputs:
Hold down [7] until two beeps sound. The output
resets.
15.0 Codepad ID/Buzzer Tone
Change
Hold down [8] continuously to change the tone of the
codepad buzzer.
There are 50 different tones, from 1500 Hz to
5000 Hz. If multiple codepads are installed, each
codepad can sound a different tone.
Bosch Security Systems | 7/05 | F01U009494B
CC404 | Operators Guide | 13.0
16.0 Testing
There are five functions for testing that your system
operates correctly.
16.1
Horn Speaker Test
Press and hold [1] until two beeps sound.
The horn speaker sounds for 2 sec.
16.2
Bell Test
Press and hold [2] until two beeps sound.
The bell output turns on for 2 sec.
16.3
Strobe Test
1. Press and hold [3] until three beeps sound.
The strobe flashes.
2. Press and hold [3] until two beeps sound.
The strobe stops flashing.
16.4
Walk Test Mode
Use Walk Test Mode to test the proper operation of
detection devices. Every time you test a zone, the
codepad sounds one long beep and the horn speaker
sounds one short beep to indicate the zone was
activated when testing.
1. Enter your four-character Master Code and press
[7 #] (for example, [2 5 8 0 7 #]).
Three beeps sound, and the STAY and AWAY
indicators flash. The codepad beeps once per
second while the system is in Walk Test Mode.
2. Activate the zones you want to test.
The codepad sounds one long beep and the horn
speaker sounds one short beep each time a zone
is faulted (unsealed) and restored.
3. When you finish testing the zones, press [#] to
exit this mode.
Two beeps sound, and the STAY and AWAY
indicators turn off. The system returns to the
disarmed state.
16.5
Test Report
This feature only applies if your system reports by
telephone. Press and hold [9] until two beeps sound.
The system sends a Test Report without sounding the
sirens.
Turning Outputs On/Off
13
Advertisement
Table of Contents
