Walk Test Mode - Bosch AMAX panel 2000 User Manual

12 en | Walk test mode
4

Walk test mode

This function allows code holders to test detection devices to ensure they are functioning
correctly. Before activating Walk test Mode, bypass any zones that are not required for
testing.
During the walk test, no walk test report is sent out to the control panel system.
To enter into Walk test Mode:
1.
2.
F.01U.249.500 | V2 | 2011.11
Enter your Code + [4] and press [#].
Two beeps sound and the STAY and AWAY indicators flash. The keypad beeps once per
second when walk test mode is active.
Unseal and seal the zones to be tested.
The keypad sounds one second beep and the siren sounds one beep each time when a
Zone status is changed.
User Guide Robert Bosch Engineering and Business Solutions Limited
AMAX panel 2000 / AMAX panel 2000 EN