Table of Contents
Advertisement
SECTION 2: INSTALLATION
SECTION 2
Installation
2.1 Mounting the camera
The camera can be mounted on any surface with sufficient strength to support it. The camera drop cable can be routed either
through the drop cable channel in the mounting bracket, or through a hole in the mounting surface covered by the mounting
bracket.
1.
Using the camera mounting bracket as a guide, mark the location of the screws that anchor the bracket to the mounting
surface. If you are routing the drop cable through base, also mark the position of the hole for the drop cable.
2.
Drill holes for the screws that anchor the base to the mounting surface. Four (4) course-threaded screws are provided.
Depending on the surface materials, more appropriate fasteners may be required.
3.
Drill a 3/4" diameter hole for the drop cable, if necessary.
4.
Route the drop cable through the hole through the mounting surface or through the cable channel in the mounting bracket,
then attach the camera to the base using appropriate fasteners.
5.
Connect the camera drop cable to video and RS-485 cables as required.
Drop cable connectors are not waterproof.
NOTE
6.
Connect the camera drop cable 12 Vdc power connector (center positive) to the power source in compliance with local codes.
7.
Attach the sun shield with the bolt provided, if not already installed.
2.2 Setting up the camera
1.
Remove the cap that covers the setup monitor and controller port (see "1.1 Camera components" on page 2 above).
2.
Insert the mating connector of the setup monitor and controller cable into the service plug.
3.
Connect a setup monitor to the BNC video connector on the setup monitor and controller cable.
4.
While observing video from the camera on the setup monitor and holding the camera in place, loosen the pan, tilt and
rotation set screws with the hex wrench provided.
4
Advertisement
Table of Contents
