Message Queuing And Message Priority; Message Priority And Call Priority; Message Indication Repetition; Color Messaging - ASCOM d81 Messenger User Manual

User Manual
Ascom d81 DECT Handset

12.3 Message Queuing and Message Priority

To notify about new incoming messages, all incoming messages are placed in a message
queue. The sorting order for the message queue depends on the system settings. By default
the messages are sorted according to message priority, and thereafter according to arrival
time.
The messages in the message queue are automatically displayed for 20 seconds until all
messages have been displayed. You can extend the time to display a message by pressing
any button. You can also close a message to immediately see the next message in the
message queue.
The messages that you do not close are put last in the message queue and remain in the
message queue until you close them. They are shown as unread in the message list and will
not be shown as read until you have closed them.
See Configuration Manual, Ascom d81 DECT Handset, TD 92674EN for more information
how to set the parameters.

12.4 Message Priority and Call Priority

The default setting is that the call information dialog always shall be visible in front of a
message at incoming calls. It is possible to configure if a message with a certain priority shall
be displayed without being interrupted by a call. By setting a call priority, the handset
compares the call priority with the message priority in order to determine which information
to be displayed, that is, the call information dialog or the message. If the message priority
and the call priority are equal, the message will be displayed.
See Configuration Manual, Ascom d81 DECT Handset, TD 92674EN for more information
how to set the parameters.

12.5 Message Indication Repetition

By default, when a new message is received/displayed, the LED starts flashing green once
and the message alert signal sounds. It is possible to configure the handset to repeat the
alert signal for an unread message every 7th second as long it is displayed. See the
handset's Configuration Manual for message settings.
Priority 1 messages with certain system-defined properties are handled as extra important
and therefore will the alert signal be repeated every 10th second in 5 minutes, or until any
key is pressed. Note that this is a system/application dependent feature and cannot be
configured in the handset.

12.6 Color Messaging

It is possible to send colored messages to handsets. The sender of a message (that is, an
application) determines the color of the message. Colored messaging can be useful for
categorizing messages. In
message, and a read message) in the message inbox (left in the figure). The messages are
indicated by a gradient colour bar behind the envelopes. In addition, a gradient color bar is
shown below the envelop when reading a colored message (right in the figure).
08 June 2012 / Ver. D
Figure 10. on page 81, there are two colored messages (a new
TD 92644EN
80