DS-7600 Series NVR User's Manual
NO-IP:
1) Enter Server Address for NO-IP.
2) Enter the domain obtained from the DynDNS website (www.no-ip.com) in the Domain
Name textbox.
3) Enter the User Name and Password registered in the NO-IP website.
HiDDNS:
1) The Server Address defaults to www.hik-online.com.
2) Enter the Device Domain Name. The domain name can only contain the lower-case letter,
numeric and '-', and it must start with the lower-case letter and cannot end with '-'.
3) If you have more than one device, you can register an account on
do some management.
4. Click the Apply button to save the settings.
Configuring SNMP
You can use SNMP protocol to get device status and parameters related information. To configure SNMP:
1. Select the SNMP tab to enter the SNMP settings interface, as shown in Figure 49.
2. Check the Enable SNMP checkbox.
3. Enter the IP address of SNMP host in the Trap Address textbox.
4. Enter the port of SNMP host in the Trap Port textbox
5. Click the Apply button to save the settings.
Note:
Before setting the SNMP, please download the SNMP software and manage to receive the device
information via SNMP port. By setting the Trap Address, the NVR is allowed to send the alarm event and
exception message to the surveillance center.
Configuring UPnP
Universal Plug and Play (UPnP) can permits the device seamlessly discover the presence of other
network devices on the network and establish functional network services for data sharing,
communications, etc. You can use the UPnP function to enable the fast connection of the device to
the WAN via a router without port mapping. To configure UPnP:
1. Select the NAT tab to enter the UPnP settings interface, as shown in Figure 50.
Figure 75 SNMP Settings Menu
www.hik-online.com
to
82