Table of Contents
Advertisement
-> Cluster Resources
There are only three fields that need to be filled in on the SMIT screen at this time: Service IP Label,
Filesystems, and Volume Groups. Special care should be taken to ensure that all shared file
systems and volume groups are listed (it's usually easy if you use the F4 pick lists):
G.4.3.8
Synchronize Cluster Resources
By this point in the configuration, you should have given HACMP all the information it needs
about your resource group. However, only one of the nodes has this configuration information, and
it needs to be on both nodes. So, it's time to synchronize the cluster resources. See Section G.10.4.2:
Synchronize Resources on page 573 for instructions.
HPSS Installation Guide
Release 4.5, Revision 2
-> Change/Show Resources/Attributes for a Resource Group
[HPSSResourceGroup]
Figure H-11 Configuring a Resource Group
September 2002
Appendix G
High Availability
557
Advertisement
Table of Contents
