Configure The Logging Policies - IBM Hub/Switch Installation Manual

Table 6-6 Accounting Policy Configuration Variables (Continued)
Display Field Name
Last Run Time
Number of Accounts
Total Bytes Used
Total Length of Files
Bytes Transferred
File Accesses
6.6.4 Configure the Logging Policies
For any HPSS server or utility which uses the HPSS logging facility, a Logging Policy can be
configured to specify which log message types get sent to the HPSS logs, and which message types
get sent to SSM for display. All that is required to configure a Logging Policy is a server name. For
configured servers, this is the same as the Server Name field on the Basic Server Configuration
window (see Section 6.5.1.1: Basic Server Configuration Variables on page 265). For servers and
utilities which do not have configurations (such as the SSM Data Server), Logging Policies can be
configured using the name by which the server identifies itself to the logging facility. These names
can be obtained by examining server startup scripts or HPSS log entries.
If no Logging Policy is configured for a server, the server will use the Default Log Policy.
However, if no default is defined (and the server doesn't have a log policy) all message types other
than Trace will be logged.
6.6.4.1 HPSS Logging Policies Window
From the HPSS Health and Status window (shown in Figure 6-1 on page 252), click on the Admin
menu, select the Configure HPSS option and click on the Logging Policies option.
Multiple changes to the logging policy list can be made at one time. When all the changes are
completed, clicking on the Save Changes button will save the modified logging policy list. As
entries are added, deleted, or modified, an indicator (NEW, DEL, MOD) will be displayed in the
Mod column. The Cancel Changes button can be used any time before the changes are saved to
HPSS Installation Guide
Release 4.5, Revision 2
Description
The starting timestamp of the current
accounting run or the completion time of
the last accounting run.
Advice: This time is set when an accounting run begins, and it is set again when
the accounting run terminates.
Total number of accounts in the system.
Total number of bytes accounted for in the
system.
The total length of bitfiles, specified by the
defined Storage Unit Size, in the HPSS
system.
The total number of bytes transferred in
and out of the HPSS system since the last
accounting run.
The total number of bitfiles accesses since
the last accounting run.
September 2002
Chapter 6 HPSS Configuration
Acceptable Default
Values Value
A date and time 0
value.
A positive 32-bit 0
integer value.
A positive 64-bit 0
integer value.
A positive 64-bit 0
integer value.
A positive 64-bit 0
integer value.
A positive 64-bit 0
integer value.
293