Configure The Storage Server Specific Information - IBM Hub/Switch Installation Manual

Chapter 6 HPSS Configuration
1. Make sure the AMU archive management software is running and the hostname is
resolved,
2. Select an OS/2 window from the Desktop and change the directory to C:\DAS,
C:> cd \das
3. At the prompt, type tcpstart and make sure that TCP/IP gets configured and that the port
mapper program is started,
C:\das> tcpstart
4. Type dasstart to start the DAS server
C:\das> dasstart
In most cases, a startup file like the following can be used to automatically start the DAS processor:
call tcpstart
das\tools\os2sleep 20
CD \AMU
START CON
START KRN
cd \das
tools\os2sleep 20
call dasstart
cd bin
start "DAS/2 AmuClient"
exit
6.8.13.5.5 Vendor Information
1. Administration Guide Distribution AML Server, Order no. DOC F00 010-B
2. Reference Guide AMU, Order no. DOC E00 005
3. Interfacing Guide DAS, Order no. DOC F00 011
6.8.14 Configure the Storage Server Specific Information
The Storage Server specific configuration entry can be created using the Storage Server
Configuration window. After the configuration entry is created, it can be viewed, updated, or
deleted through the same window.
From the HPSS Health and Status window (shown in Figure 6-1), click on the Admin menu, select
the Configure HPSS option and click on the Servers option. The HPSS Servers window will be
displayed as shown in Figure 6-5.
To add a new specific configuration, select the Storage Server entry and click on the Type-specific...
button from the Configuration button group on the HPSS Servers window. The Storage Server
Configuration window will be displayed with default values (Figure 6-40 and Figure 6-41 shown
the screen image of the Disk and Tape Storage Server configuration window, respectively). If the
394 September 2002 HPSS Installation Guide
Release 4.5, Revision 2