Table of Contents
Advertisement
G.4.3.3
Define the networks
The SMIT path for configuring each network (ethernet and RS232) is the same
% smitty hacmp
Cluster Configuration
-> Cluster Topology
At this point, you will be offered two options, IP-based Network and Non IP-based
Network.
Choose IP-based Network to configure your ethernet network. When this choice is entered,
SMITTY will query your machine for IP-based networks and provide you with a list of networks.
There will likely be only one choice, but make sure that the network you choose corresponds to the
IP addresses for your service, boot, and standby adapters.
HPSS Installation Guide
Release 4.5, Revision 2
Figure H-3 Adding Cluster Nodes
-> Configure Networds
-> Add an Network
September 2002
Appendix G
High Availability
551
Advertisement
Table of Contents
