Table of Contents
Advertisement
6.8.13 Configure the PVR Specific Information
The PVR specific configuration entry can be created using the PVR Server Configuration window.
After the configuration entry is created, it can be viewed, updated, or deleted through the same
window.
If you are configuring a PVR for StorageTek, IBM 3494/3495/3584, or ADIC AML; before
proceeding with PVR configuration you should read the PVR-specific section (Section 6.8.13.4:
StorageTek PVR and RAIT PVR Information on page 389,Section 6.8.13.3: IBM 3494/3495 PVR
Information on page 388, Section 6.8.13.2: LTO PVR Information on page 387, and Section
6.8.13.5: ADIC Automatic Media Library Storage Systems Information on page 392). These sections provide
additional vendor-specific advice on PVR/robot configuration.
The STK RAIT PVR cannot be supported at this time since STK has not yet made RAIT
generally available.
From the HPSS Health and Status window (shown in Figure 6-1), click on the Admin menu, select
the Configure HPSS option and click on the Servers option. The HPSS Servers window will be
displayed as shown in Figure 6-5.
To add a new specific configuration, select the PVR Server entry and click on the Type-specific...
button from the Configuration button group on the HPSS Servers window. The PVR Server
Configuration window will be displayed (as shown in figures 6-33 through 6-39) depending on the
selected PVR type) with default values. If the default data is not desired, change the fields with the
desired values. Click on the Add button to create the configuration entry.
To update an existing configuration, select the PVR Server entry on the HPSS Servers window and
click on the Type-specific... button from the Configuration button group. The PVR Server
Configuration window will be displayed with the configured data. After modifying the
configuration, click on the Update button to write the changes to the appropriate SFS file.
To delete an existing configuration, select the PVR Server entry on the HPSS Servers window and
click on the Type-specific... button from the Configuration button group. The PVR Server
Configuration window will be displayed with the configured data. Click on the Delete button to
delete the specific configuration entry.
Refer to the window's help file for more information on the individual fields and buttons as well as
the supported operations available from the window.
HPSS Installation Guide
Release 4.5, Revision 2
September 2002
Chapter 6
HPSS Configuration
373
Advertisement
Table of Contents
