Configure The Hpss Infrastructure On A Node - IBM Hub/Switch Installation Manual

Chapter 5 HPSS Infrastructure Configuration
*
* HPSS_LS_NAME
***************************************************************************
*/
/*
***************************************************************************
* NDAPI Specific
*
* HPSS_NDCG_KRB5_SERVICENAME - Non DCE Gateway kerberos servicename
* HPSS_KRB_TO_DCE_FILE
*
* HPSS_KCHILD_PATH
* HPSS_KCHILD_KEYTAB
* HPSS_NDCL_KEY_CONFIG_FILE
***************************************************************************
*/
krb5_Realms_to_DCE_Cells" },
/*
***************************************************************************
* Installation & Miscellaneous
*
* RPC_SUPPORTED_PROTSEQS - The RPC transport protocol used
* HPSS_PATH_ADM
* HPSS_PATH_CORE
* HPSS_PATH_TMP
* HPSS_PATH_ETC
* HPSS_AUTH_LEVEL
***************************************************************************
*/
};
#endif
5.4 Configure the HPSS Infrastructure on a Node
The HPSS Infrastructure Configuration must be performed on each node after the HPSS system is
successfully installed. The following steps should be performed:
240
- Location Server rpc group
{ "HPSS_LS_NAME",
- File to translate krb5 realm names
into DCE cellnames
- Pathname for the ndcg_kchild executable
- kerberos Keytab filename
- File containing encryption key (DCE auth)
{ "HPSS_NDCG_KRB5_SERVICENAME", "ndcg" },
{ "HPSS_KRB_TO_DCE_FILE",
{ "HPSS_KCHILD_PATH",
{ "HPSS_KCHILD_KEYTAB",
{ "HPSS_NDCL_KEY_CONFIG_FILE",
- Pathname where HPSS administrative files are placed
- Pathname where HPSS subsystem core files are placed
- Pathname where HPSS temporary files are placed
- Pathname where HPSS runtime config files are placed
- he security authorization level
{ "RPC_SUPPORTED_PROTSEQS",
{ "HPSS_PATH_ADM",
{ "HPSS_PATH_CORE",
{ "HPSS_PATH_TMP",
{ "HPSS_PATH_ETC",
{ "HPSS_AUTH_LEVEL",
{ NULL,
September 2002
"${HPSS_CDS_LS}/group"
"${HPSS_PATH_ETC}/
"${HPSS_PATH_BIN}/ndcg_kchild" },
"/krb5/v5srvtab" },
"${HPSS_PATH_ETC}/ndcl.keyconfig" },
"ncadg_ip_udp"
"${HPSS_PATH_VAR}/adm"
"${HPSS_PATH_ADM}/core"
"${HPSS_PATH_VAR}/tmp"
"${HPSS_PATH_VAR}/etc"
"2"
NULL,
},
},
},
},
},
},
},
}
HPSS Installation Guide
Release 4.5, Revision 2