Table of Contents
Advertisement
PART 2 • English
3.7 Connecting an external Usb storage device
noTE:
4.0 sTARTIng UP foR ThE fIRsT TImE
Ensure that your connections are setup properly. In case of difficulties or questions, please ask your
local dealer or service for assistance. It is recommended to follow the Installation Guide step by step.
It will guide you through the basic installation and channel searching process. It will enable you to
enjoy digital HD broadcasts just within a few minutes.
Start by selecting your language using tu. After selecting your language, press q to move the
highlight the next items and set parameters.
Display Mode:
Aspect Mode:
Antenna Power:
When all settings have been made, move the highlight to Next and press ok to continue.
The receiver will now advance to the Antenna Adjustment screen.
4.1 Antenna Adjustment
In this menu you can adjust the antenna in order to ensure best signal quality.
Band:
Frequency channel:
Now you can adjust your aerial antenna to a proper position in order to get the best signal quality
and strength indication displayed.
Afterwards press q to move the highlight to Search and press ok to start the channel scan process.
The receiver will start searching for channels. Information about the scanned frequency, found TV
and radio channels and channel scan progress is displayed on screen. When the channel scan has
been completed, the receiver will tune on the first found TV channel.
noTE:
For details to consider when using a USB storage device please refer to
chapter 1.5.
Use tu to switch the HDMI resolution to your value of choice. If
your TV set doesn't support a specific resolution you will see black
picture, but to recover you can use tu for switching to the next
or previous resolution.
Use this option to select the aspect ratio of your TV set and the
preferred conversion method. The options are: Auto (automatic
detection of aspect ratio), 4:3 Panscan (Displays 16:9 broadcasts
full screen and cut upper and lower parts of 16:9 video on your
4:3 TV), 4:3 letterbox (black bars on top and under the picture
on a 4:3 TV) and 16:9 Wide Screen or 16:9 PillarBox (Displays 4:3
broadcast with back pillars at left and right sides on your 16:9 TV)
which you can use for 16:9 TV sets.
Set to On if you use an active antenna. When set to On, 5 V will
be present on the ANT IN connector of the receiver. Select Off for
passive antennas or when connected to a house distribution system.
Allows you to select the frequency range according to your local
broadcast conditions. The default adjusted UHF range is the
mostly used one, so we recommend not to change this setting.
If you know that the VHF range is used in your country you can
select it with tu.
Select a channel/frequency that broadcasts digital TV channels in
the region where you live.
If the receiver hasn't found any channels by the end of the channel scan, it
is possible that your antenna is not installed/ aligned correctly. To ensure
good results and the proper antenna configuration, refer to qualified
professionals.
Fig. 6
7
Advertisement
Table of Contents
