Snmp Trap Mac-Notification - Cisco Catalyst 2960 Command Reference Manual

Hide thumbs Also See for Catalyst 2960:

Table of Contents

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

snmp trap mac-notification

Use the snmp trap mac-notification interface configuration command to enable the Simple Network

Management Protocol (SNMP) MAC address notification trap on a specific Layer 2 interface. Use the

no form of this command to return to the default setting.

Syntax Description

By default, the traps for both address addition and address removal are disabled.

Command Modes

Interface configuration

Command History

Usage Guidelines

Even though you enable the notification trap for a specific interface by using the snmp trap

mac-notification command, the trap is generated only when you enable the snmp-server enable traps

mac-notification and the mac address-table notification global configuration commands.

This example shows how to enable the MAC notification trap when a MAC address is added to a port:

Switch(config)# interface gigabitethernet0/2

Switch(config-if)# snmp trap mac-notification added

You can verify your settings by entering the show mac address-table notification interface privileged

EXEC command.

snmp trap mac-notification {added | removed}

no snmp trap mac-notification {added | removed}

Enable the MAC notification trap whenever a MAC address is added on this

Enable the MAC notification trap whenever a MAC address is removed from this

Modification

This command was introduced.

snmp trap mac-notification

Catalyst 2960 Switch Command Reference