Mls Qos Srr-Queue Input Dscp-Map - Cisco Catalyst 2960 Command Reference Manual

mls qos srr-queue input dscp-map

mls qos srr-queue input dscp-map
To use this command, the switch must be running the LAN Base image.
Note
Use the mls qos srr-queue input dscp-map global configuration command to map Differentiated
Services Code Point (DSCP) values to an ingress queue or to map DSCP values to a queue and to a
threshold ID. Use the no form of this command to return to the default setting.
Syntax Description
queue queue-id
dscp1...dscp8
threshold threshold-id
dscp1...dscp8
Defaults
Table 2-11
Table 2-11
DSCP Value
0–39
40–47
48–63
Command Modes
Global configuration
Command History Release
12.2(25)FX
Catalyst 2960 Switch Command Reference
2-230
mls qos srr-queue input dscp-map queue queue-id {dscp1...dscp8 | threshold threshold-id
dscp1...dscp8}
no mls qos srr-queue input dscp-map
Specify a queue number.
For queue-id, the range is 1 to 2.
Map DSCP values to an ingress queue.
For dscp1...dscp8, enter up to eight values, and separate each value with a
space. The range is 0 to 63.
Map DSCP values to a queue threshold ID.
For threshold-id, the range is 1 to 3.
For dscp1...dscp8, enter up to eight values, and separate each value with a
space. The range is 0 to 63.
shows the default DSCP input queue threshold map:
Default DSCP Input Queue Threshold Map
Queue ID–Threshold ID
1–1
2–1
1–1
Modification
This command was introduced.
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
OL-8604-04