Cisco Catalyst 2960 Command Reference Manual page 321

setup express
Examples
This example shows how to enable Express Setup mode:
Switch(config)# setup express
You can verify that Express Setup mode is enabled by pressing the Mode button:
•
•
If you hold the Mode button down for a total of 10 seconds, the configuration is deleted, and the switch
Caution
reboots.
This example shows how to disable Express Setup mode:
Switch(config)# no setup express
You can verify that Express Setup mode is disabled by pressing the Mode button. The mode LEDs do
not turn solid green or begin blinking green if Express Setup mode is not enabled on the switch.
Related Commands Command
show setup express
Catalyst 2960 Switch Command Reference
2-294
On an unconfigured switch, the LEDs above the Mode button turn solid green after 3 seconds.
On a configured switch, the mode LEDs begin blinking after 2 seconds and turn solid green after 10
seconds.
Description
Displays if Express Setup mode is active.
Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
OL-8604-04