Show Errdisable Flap-Values - Cisco Catalyst 2960 Command Reference Manual

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands

show errdisable flap-values

Use the show errdisable flap-values user EXEC command to display conditions that cause an error to
be recognized for a cause.
Syntax Description | begin
| exclude
| include
expression
Command Modes User EXEC
Command History Release
12.2(25)FX
Usage Guidelines
The Flaps column in the display shows how many changes to the state within the specified time interval
will cause an error to be detected and a port to be disabled. For example, the display shows that an error
will be assumed and the port shut down if three Dynamic Trunking Protocol (DTP)-state (port mode
access/trunk) or Port Aggregation Protocol (PAgP) flap changes occur during a 30-second interval, or if
5 link-state (link up/down) changes occur during a 10-second interval.
ErrDisable Reason
-----------------
pagp-flap
dtp-flap
link-flap
Expressions are case sensitive. For example, if you enter | exclude output, the lines that contain output
are not displayed, but the lines that contain Output are displayed.
Examples This is an example of output from the show errdisable flap-values command:
Switch> show errdisable flap-values
ErrDisable Reason
-----------------
pagp-flap
dtp-flap
link-flap
OL-8604-04
show errdisable flap-values [ | {begin | exclude | include} expression]
(Optional) Display begins with the line that matches the expression.
(Optional) Display excludes lines that match the expression.
(Optional) Display includes lines that match the specified expression.
Expression in the output to use as a reference point.
Modification
This command was introduced.
Flaps
------
3
3
5
Flaps
------
3
3
5
Time (sec)
----------
30
30
10
Time (sec)
----------
30
30
10
Catalyst 2960 Switch Command Reference
show errdisable flap-values
2-339