Cisco Catalyst 2960 Command Reference Manual page 137

Chapter 2 Catalyst 2960 Switch Cisco IOS Commands
Table 2-5
table assumes that receive desired has the same results as using the receive on keywords.
Table 2-5 Flow Control Settings and Local and Remote Port Flow Control Resolution
Flow Control Settings
Local Device
send off/receive on
send off/receive off
Examples
This example shows how to configure the local port to not support flow control by the remote port:
Switch(config)# interface gigabitethernet0/21
Switch(config-if)# flowcontrol receive off
You can verify your settings by entering the show interfaces privileged EXEC command.
Related Commands Command
show interfaces
OL-8604-04
shows the flow control results on local and remote ports for a combination of settings. The
Remote Device
send on/receive on
send on/receive off
send desired/receive on
send desired/receive off
send off/receive on
send off/receive off
send on/receive on
send on/receive off
send desired/receive on
send desired/receive off
send off/receive on
send off/receive off
Description
Displays the interface settings on the switch, including input and output flow
control.
Flow Control Resolution
Local Device
Receives only
Receives only
Receives only
Receives only
Receives only
Does not send or receive
Does not send or receive
Does not send or receive
Does not send or receive
Does not send or receive
Does not send or receive
Does not send or receive
Catalyst 2960 Switch Command Reference
flowcontrol
Remote Device
Sends and receives
Sends only
Sends and receives
Sends only
Receives only
Does not send or receive
Does not send or receive
Does not send or receive
Does not send or receive
Does not send or receive
Does not send or receive
Does not send or receive
2-111