Host Interface; Printer Interface Specifications - NEC Flash Memory Programmer PG-FP3 User Manual

7.3 HOST INTERFACE

There are two types of host interfaces: the RS-232C interface and the printer interface.
Select either using the I/F SELECT switch. When the PG-FP3 is started, the software identifies the switch setting.
Note that once an interface has been selected, it cannot be changed until power is turned off and then back on again.

7.3.1 Printer Interface Specifications

The printer interface uses the parallel port provided on most personal computers as standard. Some parallel ports,
however, do not support bidirectional communication and ECP mode. To find out whether a port supports bidirectional
communication and ECP mode, consult the manufacturer of the personal computer.
specifications, which conform to IEEE 1284-1994, are as follows:
Item
Interface connector
Operating mode
Electrical characteristics
If communication settings are not correctly performed, the Connection Port error dialog box may open. If this
happens, check if the Connection Port setting is correct.
The specifications of the interface connector and specifications of the interface cable are given on the next page.
Note Be sure to use a host computer that supports ECP mode.
CHAPTER 7 HARDWARE SPECIFICATIONS
Table 7-3. Printer Interface Specifications
Half-pitch 36-pin (receptacle) standard: 10236-52A2JL, manufacturer: 3M
Compatible mode, ECP mode supported
Data signal 74LS24 or equivalent
Pull-up resistor: 1.2 k , damping resistor: 33
Input control signal 74LS24 or equivalent
Pull-up resistor: 1.2 k
Output control signal 74LS24 or equivalent
Damping resistor: 33
User's Manual U13502EJ2V0UM00
Specification
Note
The printer interface
73