NEC Flash Memory Programmer PG-FP3 User Manual page 40

CHAPTER 4 BASIC OPERATING PROCEDURE
(2) Loading the parameter file
Select [Device] from the [Setting] pull-down menu. The dialog box for loading a parameter file will open.
Enter 78F4216.PRC in the box for Device file name: and click the [OK] button.
When the parameter file is read, the PG-FP3 is reset for synchronization, then the parameters are read.
Consequently, immediately after the parameter file is loaded, the initial status is restored, and the CHIP
mode is selected.
The Dump HEX command, Program command, Verify command, and E.P .V. command are dimmed.
Those commands are disabled until a user program is downloaded.
The screen appearing immediately after the parameter file is loaded is as shown below:
40
User's Manual U13502EJ2V0UM00