NEC Flash Memory Programmer PG-FP3 User Manual page 43

(5) Executing the E.P.V. command
The E.P .V. command can be executed by selecting [E.P .V.] from the [Procedure] pull-down menu, or by
clicking the
While the E.P .V. command is executed, the progress of execution is displayed in the log window, and a
PG-FP3 LED blinks.
Lighting of LEDs The Erase, Program, and Verify LEDs light, and the LED for the phase under
execution blinks.
Erase
Program
Verify
Normal completion of the E.P .V. processing is indicated by the message Verify OK!, which is displayed in
the log window.
(6) Verify check
Next, the program is verified independently. This is done by comparing the data stored in the PG-FP3
with the data of the target.
Verification can be executed by either selecting [Verify] from the [Procedure] pull-down menu or clicking
the button on the operation screen. While verification continues, its progress is displayed
in the log window. In addition, the Verify LED on the PG-FP3 blinks, indicating that the command is
being executed. If verification is completed normally, the message Verify OK! is displayed in the log
window.
(7) Terminating the system
To terminate FLASHPRO3, select [Exit] from the [File] pull-down menu. After terminating FLASHPRO3,
turn off power to the PG-FP3.
This completes the series of operations.
CHAPTER 4 BASIC OPERATING PROCEDURE
button on the operation screen.
Blinks while the program is being erased
Blinks during programming
Blinks while the program is being verified
User's Manual U13502EJ2V0UM00
43