Setting; Device - NEC Flash Memory Programmer PG-FP3 User Manual

5.2 Setting

When [Setting] is clicked, the pull-down menu shown below is displayed. This menu lists the commands that are
used to set the FLASHPRO3 operating environment (such as setting of the target interface).

5.2.1 Device

The [Device] command loads information such as information specific to the target device and communication
settings into FLASHPRO3 and the PG-FP3. The information on each target device is supplied to the user in the form
of a parameter file (xxxxxx.PRC). Loading this file automatically sets each parameter. Execute this command by
clicking [Device] on the [Setting] pull-down menu.
When this command is executed, the dialog box below opens. Enter the name of the parameter file for the target to
be used, or select an appropriate parameter file by clicking the button to the right of the text box, and then click the
[OK] button. This completes the setting of the parameters.
Remarks 1. The information in the parameter file sets information important for interfacing with the target. On
starting FLASHPRO3, therefore, be sure to load the parameter file with [Device].
2. The parameter file will not be recognized unless it is installed in the same directory as FLASHPRO3.
Install the file correctly by seeing Section 3.1.
3. If Type information is saved with [Save Type], parameter definition information is also set by loading
Type File with [Load Type]. It is therefore not necessary to load the parameter file again with [Device].
CHAPTER 5 COMMAND REFERENCE
User's Manual U13502EJ2V0UM00
49