Verify - NEC Flash Memory Programmer PG-FP3 User Manual

5.3.4 Verify

The [Verify] command sends the written data from the PG-FP3 and verifies the data written in the flash memory
against the sent data.
This command does not check the write level. Use this command to check whether data communication between
the PG-FP3 and the microcontroller with flash memory has been normally performed.
Execute this command by selecting [Verify] from the [Procedure] pull-down menu or by clicking the
button on the operation screen.
All the data loaded into the memory of the PG-FP3 is verified against the data of the target device. If an area is
specified, the data is verified in area units.
This command is usually used to check to see if data has been correctly written after programming.
While verification is being executed, the progress is displayed in the log window, and the Verify LED on the PG-FP3
blinks.
The following messages are displayed in the log window during verification.
NP13 Verifying 10%
NP13 Verifying 20%
:
NP13 Verifying 100%
Caution If the verify time is too short, the above message may not be displayed.
If the result of verification is OK
NP14 Verify... OK.
In Block mode, this message is displayed.
NP1D Verify... OK. BLOCK x
In Area mode, this message is displayed.
NP1D Verify... OK. AREA x
If verification fails
ER16 Verify.. Failed at xxxxxxH
ER17 Verify error.
In Block mode, this message is displayed.
ER16 Verify.. Failed at xxxxxxH
ER1D Verify error. BLOCK x
In Area mode, this message is displayed.
ER16 Verify... Failed at xxxxxxH
ER5D Verify error.. AREA x
(The error message displayed depends on the condition.)
CHAPTER 5 COMMAND REFERENCE
User's Manual U13502EJ2V0UM00
61