Chapter 8 Error Messages And Remedial Actions - NEC Flash Memory Programmer PG-FP3 User Manual

CHAPTER 8 ERROR MESSAGES AND REMEDIAL ACTIONS

Error No. Message
ER01 Illegal command.
ER02 Illegal parameter.
ER03 Host is closed.
ER04 Flash memory cannot read.
ER05 SYSTEM error.
ER06 Intel HEX format error.
ER07 Check sum error
ER08 Target initialize error.
ER09 Target no SIGNATURE.
ER0A No EEPROM.
ER0B Target return error.
ER0C Target status no return.
ER0D SW STOP!!
ER0E No character.
ER0F This DEVICE is NO BLOCK
ER10 EEPROM size over flow.
Cause Input of wrong command
Action Enter the correct command.
Cause Input of wrong parameter during command input
Action Enter the correct parameter.
Cause Incorrect interfacing with host machine
Action Check the connection between the PG-FP3 and the host.
Cause An attempt was made to read flash memory.
Action Flash memory cannot be read.
Cause PG-FP3 system error
Action The PG-FP3 may be damaged.
Cause Intel HEX format cannot be recognized.
Action Check to see if the file is in Intel HEX format, and reload the file.
Cause A checksum error was detected during loading.
Action Load the file again.
Cause Initialization with the target microcontroller cannot be made.
Action Check to see if the target device was correctly set with the TYPE
command.
Cause The set target microcontroller has no signature.
Action Check to see if the target device was correctly set with TYPE
setting.
Cause The set target microcontroller has no EEPROM.
Action Check to see if the target device was correctly set with TYPE
setting (cannot be read).
Cause The target microcontroller is not normal.
Action Communication with the target device is not normal.
Check to see if the correct communication rate was set with the
TYPE command.
Cause An error was detected during communication with the target device.
Action Check the connection with the target device again.
Cause Execution has been forcibly terminated with the Start/Stop switch.
Action Redo the processing from the beginning.
Cause An illegal character was detected in the displayed character string.
Action Turn off power to the PG-FP3 and then back on again.
Cause The set target device is not divided into blocks.
Action Block manipulation commands cannot be used if a microcontroller
that is not divided into blocks was selected with the TYPE
command.
Cause The size of the EEPROM exceeds 64 Kbytes.
Action Check the Start/End address in the TYPE setting.
User's Manual U13502EJ2V0UM00
Cause/action
87