Other; Signature; Status - NEC Flash Memory Programmer PG-FP3 User Manual

5.4 Other

When [Other] is clicked, the pull-down menu shown below is displayed. This menu mostly lists ancillary function
commands.

5.4.1 Signature

The [Signature] command reads the signature information of the target device.
Execute this command by selecting [Signature] from the [Other] pull-down menu. When it is executed, the
signature information is displayed in the log window as shown at the right.
The figure shown below shows an example of executing a PD75F4264 command.

5.4.2 Status

[Status] displays the TYPE information currently set for the PG-FP3 in the log window. This command is used to
check if the current PG-FP3 settings are correct or if the current settings are set for the PG-FP3.
Execute this command by selecting [Status] from the [Other] pull-down menu.
The following information is displayed in the log window:
Device Type
ROM Type
Start Address
End Address
RAM Size
Multiple Rate
Select Port
SIO Clock/UART bps
Flashpro Clock/Target Clock
64
CHAPTER 5 COMMAND REFERENCE
NP26 *** SIGNATURE ***
Vendor code = 10H
ID code = 7FH
Electrical Inf. = 41H
Last Address = 000FFFH
Device name = D75F4264
NP2D Signature END
User's Manual U13502EJ2V0UM00