Starting The Application; Starting The Pg-Fp3 - NEC Flash Memory Programmer PG-FP3 User Manual

3.2 STARTING THE APPLICATION

This section explains how to start the application program.
Connection of each unit and applying power
For connection of each unit, see Section 2.3.
After completing connections, turn on power to the PG-FP3. When the PG-FP3 is operating normally, the
POWER LED lights, the LED on the side of the MODE key blinks, and then the Erase, Program, and Verify LED
indicators light.
If any of the LEDs mentioned above does not light, the PG-FP3 has probably malfunctioned. If this occurs,
notify NEC.
Starting FLASHPRO3
Either select FLASHPRO3 from the Start menu or, if a shortcut has been created, double-click the shortcut to
start FLASHPRO3. If FLASHPRO3 starts correctly, the following screen is displayed.
30
CHAPTER 3 STARTING AND STOPPING
Photo 3-1. Starting the PG-FP3
User's Manual U13502EJ2V0UM00