When The Machine Is Not Operating Correctly - Develop ineo 163 User Manual

Troubleshooting
9.2

When the machine is not operating correctly

Symptom
Nothing appears on the
display.
The indicator on the
[Start] key does not light
up.
Even though the [Start]
key is pressed, no cop-
ies are made.
The machine does not
enter Copy mode.
The machine cannot be
turned on.
ineo 163/213
Possible Cause
Is only the indicator on the [Start]
key lit up in green?
Was the auto shut-off operation
performed?
Was the account number en-
tered?
ACCOUNT NO.:---
Is the "Error" indicator on the
control panel lit?
The machine is still warming up
after just being turned on.
Is the indicator on the [Interrupt]
key lit?
Has the power supply cord been
unplugged from the electrical
outlet?
Has the breaker for the electrical
circuit been tripped?
Remedy
The machine has entered Power
Save mode.
Press any key in the control panel
to cancel Power Save mode.
(See page 3-21.)
Set the power switch to "O". (See
page 3-19.)
Enter the account number ac-
cording to the procedure de-
scribed in "Entering the account
number" on page 6-34.
Follow the instructions in any
messages that appear on the dis-
play.
ineo 163 takes about 30 seconds
and ineo 213 takes about 15 sec-
onds to warm up after they are
turned on.
Wait until the machine has fin-
ished warming up.
Press the [Interrupt] key to cancel
Interrupt mode. (See page 5-65.)
Plug the power supply cord into
the electrical outlet.
Close the breaker for the electri-
cal circuit.
9
9-5