Selecting The Default "Auto" Density Level ("Density Level (A)" Parameter) - Develop ineo 163 User Manual

7
Selecting the default "AUTO" density level ("DENSITY LEVEL (A)"
parameter)
1
Display the "COPY SETTING 1" menu.
– Refer to "Displaying the "COPY SETTING 1" menu" on page 7-55.
2
Press the [+] or [,] key until "DENSITY LEVEL" is selected, and then
press the [OK] key.
3
Press the [+] or [,] key until "AUTO" is selected, and then press the
[OK] key.
7-60
UTILITY MODE
USER MANAGEMENT
ADMIN. MANAGEMENT
COPY SETTING 1
COPY SETTING 1
DENSITY LEVEL
BINDING POSITION
MARGIN SETTING
DENSITY LEVEL
AUTO
MANUAL
Utility mode/Copy mode parameters
ineo 163/213