Pflib Api Commands - Dalsa 1M28-SA User Manual

48
uncompleted writing cycle (active memory load) during write access to the EEPROM.
EEPROM access in this condition.
Table 22: Status Register 3 (Register Address REGADDR = 4D = 04H)
STATUS3_REG
Bit
0
1
2
3
4
5
6
7
Table 23 displays the defined commands.
Table 23: ADC-Module commands
C
3
Abbreviation:
C:

3.7 PFLIB API Commands

The PFLIB application programming interface enables an application programmer to control the
1M28, 1M75, and 1M150 camera's features without direct access to the CameraLink (or other)
interface. Access to the API, in order to work with most framegrabbers, is done by a separate
COMDLL, which is a low level communication interface to framegrabber's RS232 emulation.
The PFLIB API can be used with the following framegrabbers:
•
•
Note that all cameras released after January 1
RS232 settings: One start bit, 8 data bits, one stop bit, NO PARITY.
Cameras released prior to 2003 still use EVEN PARITY.
A 1M28_1M75_1M150_PFRemote_Software.zip file is provided on the floppy disk shipped
with the camera. It contains all of the files necessary to use the PFLIB API commands, including
documentation. Unzip the 1M28_1M75_1M150_PFRemote_Software.zip and copy the files
contained in the zip file to a directory on your computer. Alternately, the latest version of the
software is also available at
03-32-00525-04
PRELIMINARY
Description
AUTOLOAD, signals active Power-Up or Reload of data from EEPROM,write
access forbidden
PROM_BUSY, write access forbidden
= 1, bit always high, coding for ADC module
Not used, arbitrary logical state
Not used, arbitrary logical state
Not used, arbitrary logical state
Not used, arbitrary logical state
Not used, arbitrary logical state
Description
Execute EEPROM, access to the EEPROM starts according selected operation
Command
All framegrabbers with a looped-in COM port.
Framegrabbers with a full RS232 emulation through the CameraLink or LVDS.
http://vfm.dalsa.com/docs/docs.asp
st
, 2003 use the following low level communication
in the "Software" folder.
1M28, 1M75, and 1M150 User's Manual
Avoid
Default
0
0
1
0
0
0
0
0
DALSA