Register Descriptions - Dalsa 1M28-SA User Manual

1M28, 1M75, and 1M150 User's Manual
To modify camera registers:
1.
2.
The Registers dialog box opens:
3.
4.
5.
The register is now set to the new value. To verify the new settings, click Reread all. See the
following section for register descriptions.

3.4 Register Descriptions

Table 12: Sensor Control Registers, Address 0 to 63
REG
Decimal
Value
0
1
2
3
4
5
6
7
DALSA
PRELIMINARY
In PFRemote, open a connection with the camera. For details on opening a connection with
your camera, see Opening PFRemote on page 36.
Select Camera → Registers.
In the left side text boxes, enter the register values you wish to view.
Click Reread all.
The current register values are displayed in the right side text boxes.
In the right side text box, change the current value to the new value and click Change.
REG
Hexadecimal
Value
0
1
2
3
4
5
6
7
Read (R) / Description
Write (W)
or Command
(C)
R/W Data EEPROM
W LSB address EEPROM
W MSB address and OP-Code EEPROM
C Command SEND_PROM, content of
registers 0 – 2 are sent to the EEPROM
C/R Command RELOAD of the registers /
Status register has 3 internal states
R/W Status register 4 internal states
R/W Mode register 0 , adjust camera modes
R/W Mode register 1 , adjust camera modes
39
03-32-00525-04