Instructions For Control Of The Adc-Module - Dalsa 1M28-SA User Manual

1M28, 1M75, and 1M150 User's Manual
Table 21: Register 0 to 63 of the ADC-module
REG
DEC
0
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16 -
63
Abbreviations:
R: Read
W: Write
C: Command
Cancel: Response value for access to an undefined register

3.6 Instructions for Control of the ADC-Module

Register Addresses 0 – 3: EEPROM Control
The EEPROM control is identical to the sensor module case. Appendix C describes how to access
of the EEPROM via the RS232 interface.
Register Address 4: Status Information of the ADC-
Module
The ADC module status is shown in status register 3 (see
Table 22). Bit 2 is set to "1" and labels the ADC module. Bits 0 and 1 of status register 3 contain
information about the state of the EEPROM when storing camera settings. If the camera is in the
AUTOLOAD state (after power-on or reset of the camera), the settings are being copied from the
EEPROM to the internal registers.
information will corrupt the internal camera register.
DALSA
PRELIMINARY
REG W Function during WRITE
HEX or C
0 W Data EEPROM
1 W LSB Address EEPROM
2 W MSB Address and OP-Code
EEPROM
3 C SEND_PROM
4 C RELOAD of the internal register
5 - Not used
6 - Not used
7 - Not used
8 W Offset Channel 0
9 W Offset Channel 1
A W Offset Channel 2
B W Offset Channel 3
C - Not used
D - Not used
E - Register Slave/Master RS232,
Switches between sensor or ADC
module
F - Not used
10 – - Not used
3F
During this phase, EEPROM access is not permitted Incorrect
R Function during READ
R Data EEPROM
R Cancel = 18H
R Cancel = 18H
R Cancel = 18H
R Status3 Status for internal states
R Cancel = 18H
R Cancel = 18H
R Cancel = 18H
R Parameter for offset correction
R Parameter for offset correction
R Parameter for offset correction
R Parameter for offset correction
R Cancel = 18H
R Cancel = 18H
R Cancel = 18H
R Cancel = 18H
R Cancel = 18H
The PROM_BUSY state indicates an
47
03-32-00525-04