General Configuration; Figure 4-2 Adm. Page Kws300: Configuration/General Page - Polycom KIRK 300 Installation And Configuration Manual

Note

General Configuration

The KWS300 is pre-configured to use DHCP. If DHCP is not available, it
will fall back to static (192.168.0.1).
Prior to firmware release PCS05B_, by default, the KWS300 used static IP
address (192.168.0.1).
The current IP Address of the KWS300 can be discovered using UPnP.
For information on accessing the web based Administration Page, refer to
"How to Access the Administration Page"
This section contains information about:
• "General Configuration"
• "Wireless Server Configuration"
• "SIP Configuration"
On the Configuration/General page you define IP, DNS and NTP settings for
the KWS300.
Click Configuration, and then click General.
Figure 4-2 Adm. Page KWS300: Configuration/General page
Table 4-1 General Configuration of the KWS300
Field Explanation
Use Static IP Enable the field. It is possible to configure a
Address KWS300 using DHCP.
on page 4-1.
on page 4-3
on page 4-4
on page 4-6
General Configuration - IP
Configuring KIRK Wireless Server 300
Required
x
Optional
4–3