Wireless Server Configuration; Figure 4-3 Adm. Page Kws300: Configuration/Wireless Server Page; Table 4-1 General Configuration Of The Kws300 - Polycom KIRK 300 Installation And Configuration Manual

Wireless Server Configuration

Table 4-1 General Configuration of the KWS300
Field Explanation
IP Addr Enter the IP address of the KWS300
Enter a new network mask. Contact you
Netmask
system administrator for more information.
Enter the IP address of the default gateway.
The default gateway serves as an access
Gateway
point to another network. Contact your
system administrator for more information.
MTU
(Maximum Enter the size of the largest packet, that your
Translation network protocol can transmit
Unit)
General Configuration - DNS (Domain Name System)
Enter the name of the domain where system
Domain belongs.
Primary Enter the IP address of the Primary DNS
Server server
Secondary Enter the IP address of the Secondary DNS
Server server
General Configuration - NTP (Network Time Protocol)
Enter the address of the NTP server from
Server
which the system will obtain the current time
Time Zone Select the time zone
Click Save to save your general configuration data.
On the Configuration/Wireless Server page you configure the KWS300 to
allow subscription. If the system does not allow subscription, it is not possible
to subscribe a handset.
Click Configuration, and then click Wireless Server.
Figure 4-3 Adm. Page KWS300: Configuration/Wireless Server page
Configuring KIRK Wireless Server 300
Required
x
Optional
x
x
x
x
x
x
x
x
4–4