Status Parameters - Siemens HydroRanger 200 Instruction Manual

Status Parameters

Status parameters give the operating status of the HydroRanger 200. You can access
parameters with the hand programmer (see page 31) or with Dolphin Plus (see page 26).
Remote SCADA system access is also possible.
Parameter
P203 mA Output Value
P254 Scaled mA Input Value
[6 relay
model]
P275 Scaled Discrete Input Value Shows current value of discrete input,
P322 LCD Total Low
[6 relay
model]
P323 LCD Total High
[6 relay
model]
P341 Run Time
P342 Start Ups
P664 Temperature
P707 Rate Value
P708 Volume Rate Display
[6 relay
model]
P729 Scan Time
P806 Echo Strength
P920 Reading Measurement
P921 Material Measurement
P922 Space Measurement
P924 Volume Measurement
[6 relay
model]
P925 Flow Measurement (OCM) Current flow value, if OCM programmed
[6 relay
model]
P926 Head Measurement (OCM) Current level, if OCM programmed
[6 relay
model]
P927 Distance Measurement
7ML19985FC03 HydroRanger 200 – INSTRUCTION MANUAL
Values
0 to 22 – Current mA output
0 to 9999 – Current mA input after scaling
values vary by DI function
The last four digits of the totalizer
The first four digits of the totalizer
The number of days the HydroRanger 200
has been operating
The number of times power has been
cycled
Current temperature measured by
transducer
Current rate of material level change
Current rate of material volume change
Seconds since last level scan
Strength of primary echo
Current primary reading
Current level from P007–Span
Empty space above the material level
Current volume value, if programmed
Distance from transducer face to material
Page 23