Siemens HydroRanger 200 Instruction Manual page 137

P060 Decimal Position
Defines the maximum number of decimal places used on the LCD.
Primary Index
Values
Alters
Altered by
Related
In RUN mode, the decimal position adjusts to prevent the number of digits from exceeding
the display capabilities. To keep the decimal place from shifting, reduce the number of
decimal places to that shown at 100%.
Example:
If 100% is 15m, use two decimal places for sample readings of 15.00 or 12.15.
P061 Convert Reading [6 relay model]
Multiplies the current value by the specified amount to allow for scaling.
Primary Index
Values
Related
Examples:
• If the measured value is in feet, enter 0.3333 to display the number of yards
• For simple linear, volume conversions set POO5 to 1 (meters) and then enter the
volume measurement per unit to get the correct conversion. For example, if the
reservoir contains 100 litres per vertical meter, use 100 to get the reading in litres.
Notes:
• This method does not calculate volume. It must not be used in place of the
volume parameters if any volume dependent features (such as pump
efficiency) are used. To calculate true volumes see
• Avoid entering a value that, when multiplied by the maximum current
Reading, exceeds the display capabilities. If value exceeds four digits, EEEE is
shown.
7ML19985FC03
Level
0 No digits after the decimal point
1 1 digit after the decimal point
2 * 2 digits after the decimal point
3 3 digits after the decimal point (limited by device resolution)
• P607 Flowrate Decimal
• P051 Maximum volume
• P920 Reading Measurement
Level
Range: -999 to 9999
Preset: 1.000
• P920 Reading Measurement
HydroRanger 200 – INSTRUCTION MANUAL
Volume
(P050 to P055).
Page 127