Universal, Linear [6 relay model]
Please note that the Universal, Linear feature is only available on the HydroRanger 200,
6 relay model.
Set P600 = 4.
This flow calculation creates a piece-wise linear approximation of the head/flow curve.
This option provides best results if the curve has sharp angles joining relatively linear
sections.
Enter a Head Breakpoint at each point where the head/flow curve bends sharply (2
minimum). For combination curves (mostly linear but include 1 or more arcs), enter
numerous breakpoints along the arc, for best flow calculation accuracy.
Typical Flow Characterization
See also
Universal, Curved [6 relay model]
Please note that the Universal, Curved feature is only available on the HydroRanger 200,
6 relay model.
This calculation creates a cubic spline approximation of the head/flow curve, providing
best results if the curve is non-linear, and there are no sharp angles.
Select at least enough breakpoints from the curve to satisfy the following:
•
two breakpoints very near the minimum head
•
one breakpoint at the tangent points of each arc
•
one breakpoint at each arc apex
•
two breakpoints very near the maximum head
7ML19985FC03
HydroRanger 200 – INSTRUCTION MANUAL
on page 81.
Page 229