Terminal Board; Cables - Siemens HydroRanger 200 Instruction Manual

Terminal Board

The terminal board on the HydroRanger 200 allows all inputs and outputs to be connected
simultaneously.
Recommended torque on terminal clamping screws.
Note:
• 0.56 - 0.79 Nm
• 5 - 7 in.lbs
Please do not overtighten the screws.
TB2
2
1
RELAY 1
RELAY 2
RELAY 3
RELAY 4
RELAY 5
RELAY 6

Cables

The HydroRanger 200 transceiver requires a shielded two-wire connection to the
transducer.
Connection
mA input and mA output
sync, Temperature sensor,
discrete input, dc input
Transducer
Relay output
AC input
1.
Preferred shielding is braided screen.
Page 16
2 copper conductors, twisted, with shield
300V 0.324 - 0.0.823 mm
Maximum length: 365 m
Do not use a coaxial transducer cable extension with the
HydroRanger 200. Electrical noise interference affects
performance.
Relay to be copper conductors per local requirements to
meet 250 V 5A contact rating.
HydroRanger 200 – INSTRUCTION MANUAL
TB1
12-30 V
DC Version
DISCRETE
INPUTS
Cable Type
2
(22 - 18 AWG)
TB1
L2/N L1
TB3
SYNC
mA INPUT
SHIELD
1
4 - 20 mA
OUTPUTS
2
TS-3
SHIELD
1
2
COM
RS485
A
B
1
/drain wire,
7ML19985FC03