Dascom 1500 User Manual page 85

Troubleshooting
Problem
The top margin is wrong.
Lines are double spaced instead
of single spaced.
The printer overprints on the
same line.
The next print line starts where
the previous line ended instead
of at the left margin.
The printer overprints on the
same line while the next print
line starts where the previous
line ended instead of at the left
margin.
Solution
The top margin is the sum of the printer's top-of-
form setting, the software-specified top margin,
and the printer's TOP-MARGIN setting. Proceed
as follows:
•
Make sure that the top-of-form setting is correct.
The factory default is 0 mm (0 inch).
•
Check the software-specified top margin. Refer
to your software documentation.
•
Check the printer's TOP-MARGIN setting. See
the section "COMMON (PUSH TRAC) menu" or
"FRICTION menu" in Chapter 4, "Special mode".
Change the CR CODE setting in the printer Set-
Up mode to CR=LF+CR. See "SET-UP menu" in
Chapter 4, "Special mode".
Change the CR CODE setting in the printer Set-
Up mode to CR=LF+CR. See "SET-UP menu" in
Chapter 4, "Special mode".
Change the CR CODE setting in the printer Set-
Up mode to LF=LF+CR. See "SET-UP menu" in
Chapter 4, "Special mode".
Change the CR CODE setting in the printer Set-
Up mode to CR=LF+CR and LF=LF+CR. See
"SET-UP menu" in Chapter 4, "Special mode".
Solving problems
6-3