Recalling Factory Settings (Rcall-Fact); Saving And Exiting - Dascom 1500 User Manual

Set-Up mode

Recalling Factory Settings (RCALL-FACT)

Factory settings are those settings pre-selected at the factory. To recall (reset) the factory
settings, select the RCALL-FACT function and press the FF/LOAD/Micro Feed Up/
u
key. After that select the SAVE&EXIT function and press the SEL/MENU/EXIT
key.
Options under the Set-Up and Adjustment functions are all initialized to the factory
settings.

Saving and Exiting

To exit the set-up mode and save your setting, first select the SAVE&EXIT function and
then press the SEL/MENU/EXIT key.
Any settings changed while in the Set-Up mode are saved as the new power-on defaults
for the printer. The new defaults remain active until you change them again.
4-18
Special mode