Cisco IP Phone Administration Manual page 109

Chapter 4 Configuring Settings on the Cisco Unified IP Phones
Table 4-19 Network Configuration Menu Options (continued)
Option
LLDP-MED: SW Port Enables and disables Link Layer Discovery
LLDP Asset ID
Wireless Headset
Hookswitch Control
LLDP Power Priority
IP Addressing Mode
IP Addressing Mode
Preference for
Signaling
OL-23091-01
Description
Protocol Media Endpoint Discovery (LLDP-MED)
on the switch port. Use this setting to force the
phone to use a specific discovery protocol, which
should match the protocol supported by the switch.
Settings include:
Enabled—default
•
Disabled
•
Identifies the asset ID assigned to the phone for
inventory management.
Enables users to receive notifications of incoming
calls and answer or end calls while working in a
wireless environment.
Advertises the phone's power priority to the
switch, enabling the switch to appropriately
provide power to the phones. Settings include:
Unknown—default
•
Low
•
• High
Critical
•
Displays the IP addressing mode that is available
on the phone—IPv4 only, IPv6 only, or IPv4 and
IPv6.
Indicates the IP address version that the phone uses
during signaling with Cisco Unified
Communications Manager when both IPv4 and
IPv6 are available on the phone.
Displays one of the following options on the
phone:
Use System Default—The dual-stack phone
•
uses the default system addressing
IPv4—The dual-stack phone prefers to
•
establish a connection via an IPv4 address
during a signaling event
IPv6—The dual-stack phone prefers to
•
establish a connection via an IPv6 address
during a signaling event
Default: Use System Default
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
Device Configuration Menu
To Change
From Cisco Unified Communications Manager
Administration, choose
Device > Phone > Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose
Device > Phone > Phone Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Device
Settings > Common Device Configuration.
From Cisco Unified Communications Manager
Administration, choose Device > Device
Settings > Common Device Configuration.
4-37