Cisco IP Phone Administration Manual page 69

Chapter 3 Setting Up the Cisco Unified IP Phones
Use care not to damage wires or pipes located inside the wall when securing screws to wall studs.
Caution
Procedure
Push in the footstand adjustment button.
Step 1
Adjust the footstand, so it is flat against the back of the phone.
Step 2
Step 3 Insert two screws into a wall stud, matching them to the two screw holes on the back of the footstand.
The keyholes fit standard phone jack mounts.
Hang the phone on the wall.
Step 4
Figure 3-4
1
2
3
OL-23091-01
Parts Used in Wall Mounting the Cisco Unified IP Phone
AUX
Footstand adjustment button—Raises and lowers adjustment plate
Wall mounting screw holes
Adjustment plate—Raises and lowers phone vertically
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
Adjusting the Placement of the Cisco Unified IP Phone
3-13