Best Practices—Requirements And Recommendations - Cisco IP Phone Administration Manual

Understanding Security Features for Cisco Unified IP Phones
•
Best Practices—Requirements and Recommendations
•
•
•
•
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
1-20
Cisco Catalyst Switch (or other third-party switch)—The switch must support 802.1X, so it can act
as the authenticator and pass the messages between the phone and the authentication server. When
the exchange completes, the switch grants or denies the phone access to the network.
Enable 802.1X Authentication—If you want to use the 802.1X standard to authenticate Cisco
Unified IP Phones, be sure that you have properly configured the other components before enabling
it on the phone. See 802.1X Authentication and Status, page 4-44
Configure PC Port—The 802.1X standard does not take into account the use of VLANs and thus
recommends that only a single device should authenticate to a specific switch port. However, some
switches (including Cisco Catalyst switches) support multi-domain authentication. The switch
configuration determines whether you can connect a PC to the phone's PC port.
Enabled—If you are using a switch that supports multi-domain authentication, you can enable
–
the PC port and connect a PC to it. In this case, Cisco Unified IP Phones support proxy
EAPOL-Logoff to monitor the authentication exchanges between the switch and the attached
PC. For more information about IEEE 802.1X support on the Cisco Catalyst switches, see the
Cisco Catalyst switch configuration guides at:
http://www.cisco.com/en/US/products/hw/switches/ps708/tsd_products_support_series_home.
html
Disabled—If the switch does not support multiple 802.1X-compliant devices on the same port,
–
you should disable the PC Port when 802.1X authentication is enabled. See
Configuration Menu, page 4-32
subsequently attempt to attach a PC to it, the switch will deny network access to both the phone
and the PC.
Configure Voice VLAN—Because the 802.1X standard does not account for VLANs, you should
configure this setting based on the switch support.
Enabled—If you are using a switch that supports multi-domain authentication, you can continue
–
to use the voice VLAN.
Disabled—If the switch does not support multi-domain authentication, disable the Voice VLAN
–
and consider assigning the port to the native VLAN. See
page 4-32 for more information.
Enter MD5 Shared Secret—If you disable 802.1X authentication or perform a factory reset on the
phone, the previously configured MD5 shared secret is deleted. See
Status, page 4-44 for more information.
Chapter 1
for more information. If you do not disable this port and
An Overview of the Cisco Unified IP Phones
for more information.
Security
Security Configuration Menu,
802.1X Authentication and
OL-23091-01