Cisco IP Phone Administration Manual page 102

Device Configuration Menu
Table 4-15 Media Configuration Menu Options (continued)
Option
Recording Tone
Duration
Wideband Handset
Wideband Headset
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.6 (SCCP and SIP)
4-30
Description
Indicates the length of time in milliseconds for
which the beep tone plays.
If the value you configure here is less than one
third the interval, then this value overrides the
default provided by the Network Locale.
Range: 0 to 3000
Note For some Network Locales that use a
complex cadence, this setting applies
only to the first beep tone.
See also: Recording Tone
Indicates whether wideband is enabled or
disabled for the handset.
Default: "Use Phone Default" on Cisco Unified
Communications Manager Administration.
(This default means that the phone will be
enabled for a wideband handset only if the
phone was shipped with a wideband handset.)
Indicates whether wideband is enabled or
disabled for the headset.
Default: Disabled
Chapter 4 Configuring Settings on the Cisco Unified IP Phones
To Change
From Cisco Unified Communications Manager
Administration, choose Device > Phone > Phone
Configuration.
If Wideband Handset UI Control is enabled,
•
you or the user can choose
Preferences > Audio Preferences >
Wideband Handset.
If Wideband Handset UI Control is disabled,
•
use Cisco Unified Communications Manager
Administration and choose Device > Phone >
Phone Configuration to set this value.
If you allow this option to be user
Note
controllable (in the Wideband Handset UI
Control option), the user-configured value
takes precedence.
If Wideband Headset UI Control is enabled,
•
you or the user can use the phone and choose
> User Preferences > Audio
Preferences > Wideband Headset.
If Wideband Headset UI Control is disabled,
•
use Cisco Unified Communications Manager
Administration, choose Device > Phone >
Phone Configuration to set this value.
If you allow this option to be user
Note
controllable (in the Wideband Headset UI
Control option), the user-configured value
takes precedence.
> User
OL-23091-01