Embroidery Functions - Husqvarna Viking Designer topaz 25 User Manual

EMBROIDERY FUNCTIONS

ONE-COLOR EMBROIDERY (MONOCHROME)
design in one color only.
Note: If the Automatic Jump Stitch Trim function is activated in the
SET Menu it will still be active between the color blocks.
BASTING
design area. Basting enables you to secure your fabric to a stabilizer placed
beneath. It is especially useful when the fabric to be embroidered cannot be
hooped. Basting provides support for stretchy fabric and also shows where
the design will be placed on the fabric.
PARK POSITION/TRIM POSITION
embroidery unit in Park Position for easy storage.
hoop moves towards you, making it easy to cut jump stitches or trim fabric.
Cut the jump threads and press the button again. The hoop moves back to
Note: The Hoop Options menu will open to show the actual position.
CORNER CHECK
Corner check can be used to trace the four corners of the design. Press
move to one of the corners in the following order: upper left, upper right,
center position of the design and on the sixth press back to the current
stitch position. A crosshair will indicate the current needle position on the
GraphicDisplay.
The Corner check function also shows where the design will be embroidered
on the fabric. This makes it easier to position designs when embroidering
several designs in succession.
STEP STITCH-BY-STITCH
stitch by stitch. If the top or bobbin thread runs out or is broken, step
backwards a few stitches before starting to embroider again. Current stitch
STEP COLOR-BY-COLOR
the previous or next color. The current color block number is shown, next
to the total number of color blocks in the design, shown in brackets, in the
view the complete color block list.
1 2
5
6
Basting
Corner Check
E
3
5
6
4
M 73
MBROIDERY ODE