Ip Payload Configuration-Menu Selections - GE MDS SD Series Reference Manual

Enabling/Disabling
the IP Payload Port
Setting the Mode
MDS 05-4846A01, Rev. C
Any combination of the three VRC numbers may be entered in the menu
fields. Figure 54 illustrates the relationship between the VRC settings
and the routing of data between units.
IP Payload 1 Data
(Talk on VRC-1)
Figure 54. Virtual Radio Channel (VRC) Concept
IP Payload Configuration—Menu Selections
To enable or disable an IP payload port, proceed as follows:
1. Select on the menu. A flashing cursor appears in the field to
Status
the right of the item.
2. Press the spacebar until the desired selection is displayed (
or ), and press
Enabled
The operating mode for the IP port may be set to
,
Socket TCP Server Socket
in which it will operate. Proceed as follows to set the port mode:
1. Select on the menu. A flashing cursor appears in the field to
Mode
the right of the item.
2. Press the spacebar until the desired mode is displayed, followed by
to apply the change.
ENTER
SD Series Ref. Manual (Packet & Transparent Mode)
RADIO 1
Serial COM2 Data
(Talk on VRC-2)
IP Payload 1 Data
(Listen on VRC-1)
Ethernet/IP RTU
to apply the change.
ENTER
, or
TCP Server/Client Socket
RADIO 2
Serial COM2 Data
(Listen on VRC-2)
Serial-Based RTU
Disabled
,
UDP Socket TCP Client
to match the service
69